山西山維鴻遠K11柔韌型防水涂料
產品簡介ⅠDescription
山維鴻遠K11柔韌型防水涂料是以優質丙烯酸酯乳液和多種添加劑組成的有機液料,并以特種水泥及多種填充料組成的無機粉料,經一定比例配制成的雙組份水性防水涂料。涂刷于基體表面,固化后可形成柔韌、高強的防水涂膜。適用于衛生間、廚房、陽臺、樓地面、水池、地下室的防水、防潮。
Shanwei Hongyuan K11 flexible waterproof coating is based on high-quality acrylic emulsion and a variety of additives consisting of organic Liquid materials, and special cement and a variety of filler material composed of inorganic powder,a certain percentage of the preparation of the two-componentWater - based waterproof coating. Brush on the substrate surface, after curing can form a
flexible, high-strength waterproof coating. Applicable to Bathroom, kitchen, balcony, floor, floor, pool, basement waterproof, moisture-proof.
注意事項ⅠPrecautions
●施工時氣溫應在5℃-35℃之間,大風或雨雪天室外禁止施工;
●配制好的涂料應在1小時內完全使用完畢,使用過程中嚴禁加水;
●開封后未使用完的液料或粉料,應密封貯存;
●施工過程中注意保護防水涂膜不受破壞。
● Preparation of a good paint should be completed within 1 hour after the completion of the use of the process is strictlyprohibited water;
● configured paint should be fully used within 1 hour is completed, the use of water is strictly prohibited during the process;
● After unsealing, unused liquid or powder material should be sealed and stored.
● During the construction, pay attention to protect the waterproof coating from damage.
配比及用量ⅠRatio and Coverage
液料:粉料=10:25(重量比);1mm厚的涂膜約需涂料2kg/m2
Liquid material: powder = 10: 25 (weight ratio); 1mm thick film about 2kg / m2
施工要點ⅠApplication Instruction
●清理基層至平整、堅實;
●一袋液料配一袋粉料,先將液料倒入攪拌桶中,在攪拌的同時緩緩加入粉料,用電動攪拌器攪拌至均勻、無結塊;
●先將基層潤濕飽和但無明水,防水涂膜宜涂刷兩至三遍,每遍涂膜干燥后方可進行下道工序,時間間隔4-6小時。待涂膜完全干燥后,方可進行閉水試驗;
●防水層涂膜厚度宜1.5-2.0mm;施工時宜采用“十”字交叉涂刷的方式。
● clean up the grassroots level to a solid, solid;
● a bag of liquid with a bag of powder, the first liquid into the mixing tank, while stirring slowly adding powder, Stir with an electric stirrer to uniform, without agglomeration;
● first base wetting saturated but no water, waterproof coating should be painted two to three times, each time the coating is dry before The next process, the time interval of 4-6 hours. Until the coating is completely dry before the closed water test;
● waterproof layer coating thickness should be 1.5-2.0mm; construction should use "ten" word cross brushing way.
產品貯存ⅠStorage
存放于陰涼干燥處;在5℃-35℃正常運輸條件下,未啟封產品保質期為12個月。
Store in a cool dry place; in 5 ℃ -35 ℃ under normal transport
conditions, nopened product shelf life of 12 months.
執行標準ⅠProduct standard
GB/T23445-2009《聚合物水泥防水涂料》
GB/T23445-2009 "Polymer cement waterproof coating"
生產日期和批號ⅠProduction date and Batch number
見合格證。See the certificate.
電話:4006228811
郵箱:longcai@126.com
傳真:400-681-8888
地址:哈爾濱市道里區愛建路13號